2003 Suzuki XL-7 Base, 4WDFACTORY OEM SERVICE PROCEDURE

Main Relay Inspection

  1. Disconnect negative (-) cable at battery.
  2. Remove main relay (1} from its connector.
    Fig 1: Removing Main Relay
    G01375059Courtesy of SUZUKI OF AMERICA CORP.
  3. Check resistance between each two terminals.

    If check results are as specified, proceed to next operation check. If not, replace.

    Main relay resistance 

    1. Between terminals "A" and "B":  Infinity
    2. Between terminals "C" and "D":  79 - 95 Q (at 20°C (68°F))
    Fig 2: Checking Main Relay (Voltage Not Applied)
    G01375060Courtesy of SUZUKI OF AMERICA CORP.
  4. Check that there is continuity between terminals "A" and "B" when battery is connected to terminals "C" and "D". If malfunction is found, replace.
    Fig 3: Checking Main Relay (Voltage Applied)
    G01375061Courtesy of SUZUKI OF AMERICA CORP.
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.