Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
Fuel Pump
Remove fuel filler cap. Turn ignition on, while listening for fuel pump sounds. Fuel pump should run for 2 seconds and stop, every time ignition is cycled on and off. If fuel pump is not heard, perform appropriate procedure under FUEL PUMP CIRCUIT CHECK .
Fuel pressure pulses should be felt in fuel return line when ignition is cycled on and off. If pulses are not felt, perform appropriate procedure under FUEL PRESSURE .
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.