2003 Suzuki Vitara 2WD L4-2.0LFACTORY OEM SERVICE PROCEDURE

Heater Mode Control Switch

Removal
1. Disconnect negative (-) cable at battery.
2. Disable air bag system. Refer to Disabling Air Bag System:".
3. Pull off heater control lever knobs.

Factory service manual diagram



4. Remove meter cluster hood (1) by removing its mounting screws (2).

Factory service manual diagram



5. Remove ashtray, center garnish (1) and instrument glove box compartment.
6. Remove mode control switch (2) with heater control panel (3) from heater control lever assembly.

Factory service manual diagram



7. Remove heater control panel (3) from heater mode control switch (2).

Installation
1. Install in reverse order of removal procedure.
2. Enable air bag system. Refer to "Enabling Air Bag System:".
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.