Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2003 Suzuki Aerio AWD L4-2.0LFACTORY OEM SERVICE PROCEDURE
Steering/Suspension - Alignment Designation Update
Section Title: Front Suspension
TSB No. TS 01 02033
Division: Automotive
Category: Technical
SUBJECT:
SERVICE MANUAL UPDATE
MODEL(S):
AERIO 4WD
YEAR:
2003
CONDITION:
The model designation for the 4WD model was not included in wheel alignment specification chart found in the 2003 Aerio service manual on page 2-6.
CAUSE:
N/A
CORRECTION:
Update your service manuals with the information shown below. Related Service Manual and Page:
RH 420 SERVICE MANUAL (99500-54G10-33E) PAGE 2-6
NOTE:
The update will be reflected in the future printing of the service manuals. If the reprint date on the third cover page is later than the issue date of this bulletin, the changes will have been made in that service manual.

Specifications
NOTE:
Toe value in the specifications table was measured by using a toe-in gauge.

Disclaimer
TSB No. TS 01 02033
Division: Automotive
Category: Technical
SUBJECT:
SERVICE MANUAL UPDATE
MODEL(S):
AERIO 4WD
YEAR:
2003
CONDITION:
The model designation for the 4WD model was not included in wheel alignment specification chart found in the 2003 Aerio service manual on page 2-6.
CAUSE:
N/A
CORRECTION:
Update your service manuals with the information shown below. Related Service Manual and Page:
RH 420 SERVICE MANUAL (99500-54G10-33E) PAGE 2-6
NOTE:
The update will be reflected in the future printing of the service manuals. If the reprint date on the third cover page is later than the issue date of this bulletin, the changes will have been made in that service manual.
Specifications
NOTE:
Toe value in the specifications table was measured by using a toe-in gauge.
Disclaimer
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- β’ You smell fuel, burning insulation, or see smoke.
- β’ Brakes feel soft, pull hard to one side, or make grinding noises.
- β’ The engine overheats, stalls repeatedly, or misfires under load.
- β’ You are missing required tools, torque specs, or safe lifting equipment.
- β’ You are not confident in the next step or safety outcome.
