Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2002 Suzuki Aerio L4-2.0LFACTORY OEM SERVICE PROCEDURE
Control Assembly: Testing and Inspection
Heater Controller Inspection


- Check blower speed selector for each terminal to terminal continuity. If check result is not as specified, replace.

- Check air inlet selector for each terminal to terminal continuity. If check result is not as specified, replace.
- Check blower speed selector for each terminal to terminal continuity. If check result is not as specified, replace.
- Check air inlet selector for each terminal to terminal continuity. If check result is not as specified, replace.
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- β’ You smell fuel, burning insulation, or see smoke.
- β’ Brakes feel soft, pull hard to one side, or make grinding noises.
- β’ The engine overheats, stalls repeatedly, or misfires under load.
- β’ You are missing required tools, torque specs, or safe lifting equipment.
- β’ You are not confident in the next step or safety outcome.
