Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
Test C: Engine Control Module Power & Ground Circuit Check (Engine Does Not Start): Condition
When ignition switch is turned to ON position, main relay is energized by the Engine Control Module (ECM) and supplies ECM with main power. As ECM is supplied with main power, it will turn ON the MIL. After engine starts, MIL will turn OFF if no malfunction is detected. If a malfunction is detected, MIL will remain ON until system is repaired.
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.