2001 Suzuki Swift GL, AutomaticFACTORY OEM SERVICE PROCEDURE

Special Tools

NOTE: Scan tools save a great deal of diagnostic time and help prevent replacement of good parts. Most procedures and diagnostic tests related to computerized engine control system are intended to be used in conjunction with a scan tool. Any computer related diagnosis without a scan tool is NOT recommended.

The computerized engine control system is diagnosed using a Tech 2 or other OBD-II compatible scan tool. However, other tools are needed to aid in diagnosing problems. These tools include a tachometer (inductive pick-up), a non-powered test light, Digital Volt-Ohmmeter (DVOM) with 10-megohm input impedance (minimum), vacuum pump and vacuum gauge, High Energy Ignition (HEI) spark tester, fuel pressure gauge, fuel injector test light (noid-light), and fused jumper wires. A test light, rather than a voltmeter, must be used when indicated by a diagnostic test procedure.

Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.