Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2000 Suzuki Swift GL, AutomaticFACTORY OEM SERVICE PROCEDURE
Electrical Component Locator: Switches
SWITCHES
| Component | Component Location |
|---|---|
| A/C Dual Cut Switch | In high pressure line, behind receiver-drier. |
| Back-Up Light Switch | On top of transaxle. |
| Brake Fluid Level Switch | In brake fluid reservoir. |
| Brakelight Switch | On top of brake pedal bracket. |
| Clutch Pedal Position Switch | On bracket, above clutch pedal. |
| Oil Pressure Switch | On left side of engine block, above oil filter. |
| Parking Brake Switch | At base of park brake lever. |
| Power Steering Pressure Switch | In lower right of engine compartment. |
| Transmission Range Switch | On right side of transaxle. |
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.