Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2000 Suzuki Swift GL, AutomaticFACTORY OEM SERVICE PROCEDURE
Electrical Component Locator: Connectors
CONNECTORS
| Component | Component Location |
|---|---|
| C19 (16 Pin) | At right rear of engine compartment. |
| C20 (16 Pin) | At right rear of engine compartment. |
| C24 (12 Pin) | Behind glove box. |
| C29 | At right rear of engine compartment. |
| E05 (2 Pin) | At right rear of engine compartment. |
| E06 (16 Pin) | At right rear of engine compartment. |
| E07 (16 Pin) | At right rear of engine compartment. |
| E54 (8 Pin) | Behind left side of dash. |
| E55 (12 Pin) | Behind left side of dash. |
| E56 (14 Pin) | Under left side of dash. |
| G02 (5 Pin) | Behind left side of dash. |
| G04 (13 Pin) | Behind left side of dash. |
| G05 (12 Pin) | Behind left side of dash. |
| G06 (8 Pin) | Behind left side of dash. |
| G07 (2 Pin) | Behind left side of dash. |
| G25 (12 Pin) | Behind glove box. |
| G27 (2 Pin) | At right kick panel. |
| G28 (3 Pin) | At right kick panel. |
| J06 (2 Pin) | At right kick panel. |
| J15 (2 Pin) | Behind left side of dash. |
| K01 (3 Pin) | At right kick panel. |
| L01 (14 Pin) | Under rear seat. |
| L03 (13 Pin) | Behind left side of dash. |
| L10 (2 Pin) | Under rear seat. |
| L11 (2 Pin) | Under rear seat. |
| L12 (4 Pin) | Under rear seat. |
| L28 (6 Pin) | Under right "C" pillar trim. |
| L29 (4 Pin) | Under rear seat. |
| L30 (2 Pin) | Under rear seat. |
| L34 (3 Pin) | Under rear seat. |
| L36 (3 Pin) | Under rear seat. |
| L40 (2 Pin) | Under rear seat. |
| M01 (6 Pin) | Under right "C" pillar trim. |
| M08 (1 Pin) | Under left "C" pillar trim. |
| M09 (1 Pin) | Under left "C" pillar trim. |
| Q02 (5 Pin) | Behind left side of dash. |
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.