1998 Suzuki Swift AutomaticFACTORY OEM SERVICE PROCEDURE

Relieving Fuel Pressure

CAUTION: DO NOTΒ  perform this procedure when engine is hot. Doing so may have an adverse effect on catalytic convertor.
  1. Place transmission in Neutral (M/T) or Park (A/T). Set parking brake and block drive wheels. Disconnect fuel pump relay. See FUEL PUMP RELAY LOCATIONΒ  table.
  2. Remove fuel filler cap to release fuel vapor pressure in fuel tank. Reinstall fuel filler cap. Start engine and let run until it stalls. After engine stalls, crank engine 2-3 times for about 3 seconds to dissipate remaining fuel pressure in fuel lines. To restore normal operation, reinstall fuel pump relay.
FUEL PUMP RELAY LOCATION

Application Location
Esteem & Swift Engine Compartment Relay Box
Sidekick
1.6L Passenger Compartment, Attached To Heater Case
1.8L Passenger Compartment, Behind Glove Box
X-90 Passenger Compartment, Attached To Heater Case
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.

Rather have a pro handle this?

A certified mobile mechanic comes to your home or office. They bring the tools, you stay comfortable. No tow truck, no waiting room, no surprises.

Comes to youSame-day available12-month warranty
Get a Free Quote

No obligation. See pricing before you book.