Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
1997 Suzuki Swift StandardFACTORY OEM SERVICE PROCEDURE
Throttle Position (TP) Sensor
- Disconnect negative battery cable and TP sensor connector. See Fig 1 . Using an ohmmeter, check resistance between indicated terminals. See THROTTLE POSITION (TP) SENSOR RESISTANCEΒ table.
- If resistance is not as specified, adjust TP sensor. See ADJUSTMENTS article. If resistance is not as specified after adjustment, replace TP sensor. For further diagnostic procedures, see TESTS W/CODES article.
THROTTLE POSITION (TP) SENSOR RESISTANCE
| Application | Ohms | ||
|---|---|---|---|
| Between Terminals "A" & "C" | (1) 100-20,000 | ||
| Between Terminals "A" & "D" | 2870-5330 | ||
|
|||
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- β’ You smell fuel, burning insulation, or see smoke.
- β’ Brakes feel soft, pull hard to one side, or make grinding noises.
- β’ The engine overheats, stalls repeatedly, or misfires under load.
- β’ You are missing required tools, torque specs, or safe lifting equipment.
- β’ You are not confident in the next step or safety outcome.
