Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
1997 Suzuki Swift StandardFACTORY OEM SERVICE PROCEDURE
Throttle Position (TP) Sensor
NOTE:
See PIN VOLTAGE CHARTS
article and appropriate wiring diagrams in WIRING DIAGRAMS
article for PCM connector and wire terminal identification.
| Application | Volts | ||||
|---|---|---|---|---|---|
| With .140" (3.5 mm) Clearance At Stop Screw | 0.98-1.02 | ||||
|
|||||
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.