Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
1997 Suzuki Swift AutomaticFACTORY OEM SERVICE PROCEDURE
Torque Specifications
TORQUE SPECIFICATIONS
| Application | Ft. Lbs. (N.m) | |
|---|---|---|
| Clutch Cable Bracket Bolts | 14-20 (19-27) | |
| Clutch Cable Joint Nut | 8-12 (11-16) | |
| Clutch Start Switch Lock Nut | 7-11 (9-15) | |
| Engine Mount Nuts | 30-44 (40-60) | |
| Exhaust Pipe Bolts | 44 (60) | |
| Flywheel Mounting Bolts | 56 (78) | |
| Gear Shift Control Shaft | 11-15 (15-20) | |
| Gear Shift Extension Rod Nut | 18-30 (25-40) | |
| Pressure Plate-To-Flywheel Bolts | 17 (23) | |
| Starter Mount Bolts | 16-23 (22-31) | |
| Transaxle-To-Engine Nuts & Bolts | ||
| Esteem | 65 (90) | |
| Swift | 30-44 (40-60) | |
| INCH Lbs. (N.m) | ||
| Clutch Cable Mounting Bolts | 97 (11) | |
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.