Safety Warning

DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.

1997 Suzuki Swift AutomaticFACTORY OEM SERVICE PROCEDURE

Throttle Position (TP) Sensor

WARNING: This page is about a different car, the 1997 Suzuki Esteem. However, it is still accessible from the selected car via links, so may be relevant.

THROTTLE POSITION (TP) SENSOR RESISTANCE ⁽¹⁾

Application

Ohms

Between Terminals "A" & "B"

With .012" (.30 mm) Clearance At Stop Screw

0-3000

With .024" (.60 mm) Clearance At Stop Screw

Infinity

Between Terminals "A" & "D"

2870-5330

Between Terminals "A" & "C"

At Idle

130-10,930

At Wide Open Throttle

⁽²⁾ 2020-14,640

⁽¹⁾	See Fig 1 for terminal identification.

⁽²⁾	There should be more than 2000 ohms difference between idle and wide open throttle resistance.

NOTE: See PIN VOLTAGE CHARTS article and appropriate wiring diagrams in WIRING DIAGRAMS article for PCM connector and wire terminal identification.

Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

Shop Manual-Ready Tools Compare Repair Quote Quote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

• You smell fuel, burning insulation, or see smoke.
• Brakes feel soft, pull hard to one side, or make grinding noises.
• The engine overheats, stalls repeatedly, or misfires under load.
• You are missing required tools, torque specs, or safe lifting equipment.
• You are not confident in the next step or safety outcome.