1995 Suzuki Swift AutomaticFACTORY OEM SERVICE PROCEDURE

TP Sensor Resistance Inspection

Unplug TP sensor connector. Using ohmmeter, check resistance between terminals of TP sensor connector. See Fig 1 and Fig 2 . See the THROTTLE POSITION (TP) SENSOR RESISTANCEΒ  table.

Fig 1: Throttle Position (TP) Sensor Terminals
G95I32357Courtesy of SUZUKI OF AMERICA CORP.
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.