1995 Suzuki SamuraiFACTORY OEM SERVICE PROCEDURE

Starter Specifications

STARTER SPECIFICATIONS

Application Specification
Brush Minimum Length .45" (11.5 mm)
Commutator Outside Diameter
Standard Diameter 1.26" (32.0 mm)
Wear Limit 1.22" (31.0 mm)
Armature Maximum Runout .015" (.40 mm)
Insulator Depth
Standard Depth .015-.023" (.40-.60 mm)
Wear Limit .008" (.20 mm)
Cold Cranking Amperage & Voltage (1)
No-Load Maximum Current Draw At 11 Volts 60 Amps
(1) Information is not available from manufacturer.
Chapter Navigation
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.