Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
1995 Suzuki Esteem GLX, AutomaticFACTORY OEM SERVICE PROCEDURE
Fuel Pump Circuit Test
- With ignition on and engine off, listen for operating sound of fuel pump. Pump should run for 2 seconds after switch is turned on. If operating sound is not heard, go to next step. If operating sound is heard for 2 seconds, fuel pump circuit is okay.
- Remove fuel pump relay. See Figure . Install jumper wire between terminals No. 1 and 2. See Figure . If pump operates with ignition on, go to step 4).
- If pump does not operate, check continuity of Red/Blue or Pink wire between fuel pump relay and pump (in tank). If continuity exists, replace pump. If continuity does not exist, repair appropriate circuit.
- Check fuel pump relay. See RELAYS under RELAYS & SOLENOIDS. If fuel pump relay is okay, check continuity of Black/White wire between fuel pump relay and fuel pump or Yellow/Black wire between fuel pump relay and ECM connector terminal A7. If circuits are okay, replace ECM.
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.