1992 Suzuki Swift GTFACTORY OEM SERVICE PROCEDURE

Torque Specifications

TORQUE SPECIFICATIONS

Application Ft. Lbs. (N.m)
Air Temperature Sensor
Except SOHC 26-40 (35-54)
SOHC 10-12 (14-16)
Coolant (Water) Temperature Sensor
DOHC (1)
SOHC 15-22 (20-30)
Fuel Rail Mounting Bolts 14-20 (19-27)
Oxygen Sensor 33-41 (45-55)
Spark Plugs 18-22 (24-30)
Throttle Body Mounting Bolts & Nuts 13-20 (18-27)
INCH Lbs. (N.m)Β 
EGR Temperature Sensor 72-168 (8.1-18.9)
Fuel Feed Pipe Bolts
Except DOHC 71-106 (8.0-11.9)
DOHC (2)
Fuel Pressure Regulator Screws 31 (3.5)
Idle Speed Control Valve Screws 31 (3.5)
Injector Cover Screws
Except SOHC 17 (1.9)
SOHC 25-35 (2.8-3.9)
Throttle Position Sensor: SOHC A/T 14-20 (1.5-2.2)
Throttle Switch: SOHC M/T 14-20 (1.5-2.2)
Upper-To-Lower Throttle Body Screws
Except SOHC 31 (3.5)
SOHC 25-35 (2.8-3.9)
(1) Tighten to 48-132 INCH lbs. (5.4-14.9 N.m).
(2) Tighten to 13.5-20 ft. lbs. (18-28 N.m).
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.