1992 Suzuki Sidekick JS, 2D UtilityFACTORY OEM SERVICE PROCEDURE

System Test

  1. Warm engine to normal operating temperature. Turn engine off. Ensure throttle opener slightly opens throttle valve with engine off and while engine is cranking. If throttle valve opens, go to step 3).
  2. If throttle valve does not open, check throttle opener diaphragm. See THROTTLE OPENER DIAPHRAGM heading below. Replace throttle opener if defective. If throttle opener is okay, adjust throttle opener. See ADJUSTMENTS article in this section.
  3. Note if throttle opener rod retracts within one second after engine starts. If rod retracts, check throttle opener adjustment. See ADJUSTMENTS article in this section. Adjust as necessary. If rod does not retract, go to next step.
  4. Check vacuum hoses to throttle opener. If vacuum hoses are okay, check throttle opener diaphragm. See THROTTLE OPENER DIAPHRAGM. Replace components as necessary. If components are okay, go to next step.
  5. Check throttle opener vacuum switching valve. See appropriate THROTTLE OPENER VACUUM SWITCHING VALVE (VSV). If VSV is okay, go to next step. Replace VSV if defective.
  6. Turn ignition on. Check for battery voltage between ground and ECM terminal No. B14 (Light Green/White wire). ECM is located near upper left corner of instrument panel.
  7. If battery voltage is present, go to next step. If battery voltage is not present, check for defective connection at VSV, defective wiring between ECM and VSV or control relay. If wiring and connections are okay, replace ECM and recheck operation.
  8. While cranking engine, check for voltage on ECM connector terminal No. B14 (Light Green/White wire). If voltage is not present, ECM is okay. If voltage is present, go to next step.
  9. While cranking engine, check for battery voltage on ECM connector terminal No. B11 (Black/Yellow wire). If battery voltage is present, go to next step. If battery voltage is not present, check for open or short to ground in Black/Yellow wire between ECM and starter.
  10. Check for defective connection at ECM. If connection is okay, replace ECM and recheck system operation.
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

Shop Manual-Ready ToolsCompare Repair QuoteQuote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.

Rather have a pro handle this?

A certified mobile mechanic comes to your home or office. They bring the tools, you stay comfortable. No tow truck, no waiting room, no surprises.

Comes to youSame-day available12-month warranty
Get a Free Quote

No obligation. See pricing before you book.