1992 Suzuki Samurai JAFACTORY OEM SERVICE PROCEDURE

Fuel Injector Circuit Test

  1. Ensure fuel pressure is within specification. See BASIC TESTING article in this section. If fuel pressure is not within specification, see appropriate FUEL PUMP CIRCUIT TEST under FUEL DELIVERY  .
  2. Check fuel injector operation. See FUEL INJECTOR(S) under FUEL CONTROL  . Turn ignition off. Disconnect injector connector and measure resistance between injector connector terminals. Resistance should be 0.8-1.8 ohms at 68°F (20°C). If resistance is not as specified, replace injector. If resistance is within specification, go to next step.
  3. Disconnect ECM connector "B" from ECM. Measure resistance between connector terminals B8 (Red Wire) and B17 (Yellow wire). Resistance should be 0.8-1.8 ohms at 68°F (20°C). If resistance is not as specified, check Red and Yellow wires for short, open or poor connections.
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

Shop Manual-Ready ToolsCompare Repair QuoteQuote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.

Rather have a pro handle this?

A certified mobile mechanic comes to your home or office. They bring the tools, you stay comfortable. No tow truck, no waiting room, no surprises.

Comes to youSame-day available12-month warranty
Get a Free Quote

No obligation. See pricing before you book.