1990 Suzuki Sidekick JSFACTORY OEM SERVICE PROCEDURE

EGR System Test (CALIF. Swift)

  1. To check system operation, place transaxle in Park (A/T) or Neutral (M/T). Apply parking brake.
  2. With coolant temperature less than 122°F (50°C) on DOHC models or 104 °F (40°C) on SOHC models, start engine and operate at high RPM. EGR valve diaphragm should not move.
  3. Warm engine to normal operating temperature. Operate engine at high RPM. EGR valve diaphragm should move up.
  4. If EGR valve does not operate as specified, check for misrouted, restricted, clogged or deteriorated vacuum hoses. If vacuum hoses are okay, check EGR valve and EGR modulator (backpressure transducer). See EGR VALVE  and EGR MODULATOR (BACKPRESSURE TRANSDUCER)  under EXHAUST GAS RECIRCULATION (EGR) in this article.
  5. If EGR valve and EGR modulator (backpressure transducer) are okay, check EGR Vacuum Switching Valve (VSV). See EGR VACUUM SWITCHING VALVE (VSV)  under EXHAUST GAS RECIRCULATION (EGR) in this article.
  6. If VSV is okay, check wiring and ECM. The ECM will set a Code 51 if EGR system failure is present. See TESTS W/CODES article for system diagnosis.
  7. To check for clogged passages, allow engine to idle. Open EGR valve by hand. Engine should decrease. If no decrease in engine speed occurred, check for clogged EGR passages.
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.