Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
1990 Suzuki Sidekick JSFACTORY OEM SERVICE PROCEDURE
Electrical Component Locator: Switches
SWITCHES LOCATION
| Component | Location |
|---|---|
| A/C High/Low Pressure Switch | At right front of engine compartment, on receiver-drier. |
| Back-Up Light Switch | On side of transmission. |
| Brake Fluid Level Switch | On top of brake fluid reservoir. |
| Clutch/Start Switch | On top of clutch pedal bracket. |
| Idle Switch (M/T) | Integral part of throttle position sensor. |
| Oil Pressure Switch | On side of engine block, above oil filter. |
| Shift Switch (A/T) | On right side of transmission. See Figure . |
| Stoplight Switch | On top of brake pedal bracket. |
| Transmission Oil Pressure Switch | Inside transmission oil pan. See Figure . |
| 5th Gear Switch (M/T) | On left side of transmission. See Figure . |
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.