1990 Suzuki Sidekick JSFACTORY OEM SERVICE PROCEDURE

Bench Testing: Rectifier

  1. Using an ohmmeter, check for continuity between ground and "B" terminal. Connect one lead of ohmmeter to the "B" terminal and the other to ground. Swap the leads and recheck for continuity. See Fig 1.
  2. In one direction there should be about 10 ohms of resistance and in the other direction there should be an infinite reading, indicating no continuity. If not, replace the rectifier.
Fig 1: Testing Rectifier Diode Continuity
G104896Courtesy of SUZUKI OF AMERICA CORP.
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.