1990 Suzuki SamuraiFACTORY OEM SERVICE PROCEDURE

Fuel System Pressure Release

WARNING: ALWAYS relieve fuel pressure before disconnecting any fuel injection-related component. DO NOTΒ  allow fuel to contact engine or electrical components.
  1. Place transmission in Neutral or Park and set parking brake. Loosen fuel tank filler cap to relieve tank vapor pressure. Remove harness connector from fuel pump relay which is located under extreme right side of dash, mounted at the top front of ECM. See the FUEL PUMP RELAY LOCATIONΒ  table.
  2. Start engine and let idle until engine dies. Crank engine 2-3 times to ensure fuel pressure is dissipated from system. Turn ignition off and remove key. Fuel system may now be opened safely. When loosening fuel line, hose or fitting, cover it with shop towel to absorb leaking fuel. When repair is completed, reconnect relay.
FUEL PUMP RELAY LOCATION

Model Location
Samurai Under Far Right Side Dash, Above ECM
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.

Rather have a pro handle this?

A certified mobile mechanic comes to your home or office. They bring the tools, you stay comfortable. No tow truck, no waiting room, no surprises.

Comes to youSame-day available12-month warranty
Get a Free Quote

No obligation. See pricing before you book.