1989 Suzuki Sidekick JA, AutomaticFACTORY OEM SERVICE PROCEDURE

Idle Speed Control (ISC) System

  1. Warm engine to operating temperature. Monitor engine RPM with engine idling. Turn headlights and blower fan on. Idle speed should increase, or at least be maintained at previous level. If so, system is functioning properly. If not, check electrical load signals to control unit. See ELECTRICAL LOAD in ENGINE SENSORS & SWITCHESΒ  in this article.
  2. If electrical load signals are okay, check ISC solenoid. See ISC SOLENOIDΒ  . If solenoid is okay, check harness between ISC solenoid and control unit. If harness is okay, control unit is defective.
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.