1989 Suzuki Sidekick JA, AutomaticFACTORY OEM SERVICE PROCEDURE

Pick-Up Coil

  1. Disconnect ignition secondary coil and attach to ground. Remove distributor cap and rotor. Ensure that reluctor teeth are NOT aligned with pick-up coil. See Fig 1 . Using a voltmeter, attach positive lead to ignition coil negative terminal and negative lead to ground.
  2. Voltmeter should read 12 volts. Insert screwdriver between reluctor and pick-up coil. Each time screwdriver is inserted, voltmeter should fluctuate up to one volt. If voltmeter does not fluctuate, replace pick-up coil.
Fig 1: Distributor Pick-up Coil & Reluctor Test Arrangement
G119581Courtesy of SUZUKI OF AMERICA CORP.
PICK-UP COIL AIR GAP

Application Clearance In. (mm)
Sidekick .008-.016 (.2-.4)
PICK-UP COIL RESISTANCE - Ohms @ 68Β°F (20Β°C)

Application Ohms
Sidekick Information Not Available
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.