1989 Suzuki Sidekick JA, AutomaticFACTORY OEM SERVICE PROCEDURE

Fuel Pressure Test

  1. Start engine and warm to normal operating temperature. Relieve fuel system pressure. See FUEL PRESSURE RELEASE in the previous heading. Attach Pressure Gauge Set (09912-58412) at fuel filter inlet union. See Fig 1 . Start engine and ensure that there is no leakage at pressure gauge connection.
  2. Measure and record fuel pressure with pump operating and engine off. Start engine. Measure and record fuel pressure with engine idling. Fuel pressure for both procedures should be 34.1-39.8 psi (2.4-2.8 kg/cm2 ). Turn fuel pump off and allow one minute for pressure to reduce. Minimum fuel pressure should be 21.3 psi (1.5 kg/cm2 ).
  3. If pressure is not within specification, check for defective fuel pump, pressure regulator or restriction in fuel system. Repair as necessary. Remove pressure gauge and start engine to ensure that no fuel leakage exists.
Fig 1: Fuel System Pressure Testing
G119576Courtesy of SUZUKI OF AMERICA CORP.
REGULATED FUEL PRESSURE

Application (1) Engine Off psi (kg/cm2 ) psi (kg/cm2 ) At Idle
Sidekick 21.3 (1.5) 34.1-39.8 (2.4-2.8)
(1) After running engine, turn ignition to the "OFF" position.
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.