1989 Suzuki Sidekick JA, AutomaticFACTORY OEM SERVICE PROCEDURE

Ignition Timing: Notes

IGNITION TIMING SPECIFICATIONS (Degrees BTDC @ RPM)

Application Man. Trans. Auto. Trans.
Sidekick 8 @ 800 8 @ 800
  1. Inspect timing indicator and crankshaft pulley mark. Clean marks if necessary and warm engine to normal operating temperature. Turn all accessories off. Attach timing light to No. 1 spark plug wire. Ensure idle speed is correct.
  2. Aim timing light at crankshaft pulley. If timing is not within specification, loosen distributor hold-down bolt and rotate distributor to obtain correct ignition timing. Tighten distributor hold-down bolt and recheck timing.
Fig 1: Sidekick Ignition Timing Mark Location
G119562Courtesy of SUZUKI OF AMERICA CORP.
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.