1989 Suzuki SamuraiFACTORY OEM SERVICE PROCEDURE

Feedback System Mixture Check

  1. Start engine and warm to normal operating temperature. Ensure oxygen sensor is functioning properly. Locate dwell duty check connector at center of firewall. Remove rubber cap and connect positive lead of dwell meter to Blue/Red wire terminal and negative dwell meter lead to Black/Green wire terminal. Place dwell meter on the 6-cylinder scale.
  2. Increase idle speed to 1500-2000 RPM for 30 seconds. Allow engine to idle and monitor dwell meter. If feedback system is functioning properly, dwell meter should fluctuate between 10 and 50 degrees, while not remaining excessively high or low.
  3. If dwell reading remains low, mixture is lean. If dwell reading remains high, mixture is rich. Adjust air/fuel mixture. See the ADJUSTMENTS article in this section.
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.

Rather have a pro handle this?

A certified mobile mechanic comes to your home or office. They bring the tools, you stay comfortable. No tow truck, no waiting room, no surprises.

Comes to youSame-day available12-month warranty
Get a Free Quote

No obligation. See pricing before you book.