Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
1987 Suzuki Samurai BaseFACTORY OEM SERVICE PROCEDURE
Installation Procedure
WARNING: This page is about a different car, the 2007 Suzuki XL7. However, it is still accessible from the selected car via links, so may be relevant.
- Install the liftgate window into the opening. Refer to ADHESIVE INSTALLATION OF STATIONARY WINDOWS (WINDSHIELD) and ADHESIVE INSTALLATION OF STATIONARY WINDOWS (LIFTGATE) .
- Connect the liftgate window defogger electrical connectors to the bus bar.
- Install the liftgate trim. Refer to LIFTGATE TRIM PANEL REPLACEMENT (UPPER) and LIFTGATE TRIM PANEL REPLACEMENT (LOWER) .
- Remove the double layer of masking tape around the perimeter of the painted surfaces and the interior trim.
- Close the liftgate.
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.