1987 Suzuki Samurai BaseFACTORY OEM SERVICE PROCEDURE

Microswitch Check Connector

  1. Warm engine to normal operating temperature. Turn off ignition. Using ohmmeter, connect negative probe to check terminal with Light Green wire coming from lower right side of dashboard below glove box. See Fig 1 . Connect positive probe to ground.
  2. Turn ignition on and observe ohmmeter indicator. See MICROSWITCH TESTΒ  table for proper ohmmeter indicator movement. If results of the test do not correspond with the MICROSWITCH TESTΒ  table, test idle and wide open microswitches for continuity.
Fig 1: Microswitch Check Terminal Location
G48414Courtesy of SUZUKI OF AMERICA CORP.
MICROSWITCH TEST

Throttle Valve Position Indicator Deflection
Idle Position Swing
Half Open Stay After Deflection
Full Open Swing
NOTE: If ohmmeter indicator does not deflect, reverse connection of ohmmeter. Connect negative probe to body and positive probe to check connector.
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.