Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2025 Subaru Outback BaseFACTORY OEM SERVICE PROCEDURE
Front Seat Belt
| (1) | Adjuster shoulder anchor | ||
| (2) | Locking washer | ||
| (3) | Belt ASSY front OUT RH | ||
| (4) | Belt ASSY front INN RH(1) | ||
| (5) | Spring wave washer | ||
| (6) | Belt ASSY front INN LH(1) | ||
| (7) | Belt ASSY front OUT LH (only on driver's side with lap belt pretensioner) | ||
|
|||
Tightening torque: N.m (kgf-m, ft-lb)
T1: 7.5 (0.8, 5.5)
T2: 30 (3.1, 22.1)
T3: 38 (3.9, 28.0)
T4: 53 (5.4, 39.1)
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.