Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2025 Subaru Outback BaseFACTORY OEM SERVICE PROCEDURE
Central Gateway Control Module: Installation
CAUTION:
- When The Central Gateway Control Module Has Been Replaced, Be Sure To Perform The Module Registration.
- Before Handling The Airbag System Components, Refer To "Caution" Of "General Description" In "Airbag System". Ref. To Airbag System>General Description>Caution .
- When The Control Module Related To Immobilizer Has Been Replaced, Be Sure To Perform The Registration Of Immobilizer System. (Model Without Keyless Access With Push Button Start)
- Except For C5 Model, Refer To "Type G" Described In "Registration Manual For Immobilizer".
- For C5 Model, Refer To "Type I" Described In "Registration Manual For Immobilizer".
- Install The Central Gateway Control Module.
Tightening Torque:
1.8 N.M (0.2 Kgf-M, 1.3 Ft-Lb)
- Install The Speaker Assembly Center. Ref. To Entertainment & Monitoring>Front Speaker>Installation .
- Install The Center Information Display Assembly And The Ornament Panel Mid Passenger. Ref. To Entertainment & Monitoring>Cockpit Display>Installation .
- Install The Cover Assembly Front. Ref. To Exterior/Interior Trim>Console Box>Installation .
- Install The Grip And Boot. Ref. To Control Systems>Select Lever>Installation .
- Install The Cover Center Upr Or The Driver Monitoring Unit Assembly. Ref. To Instrumentation/Driver Info>Driver Monitoring Unit>Installation .
- Install The Visor Assembly. Ref. To Instrumentation/Driver Info>Combination Meter>Installation .
- Install The Cover Lwr Driver. Ref. To Exterior/Interior Trim>Instrument Panel Lower Cover>Installation .
- Connect The Ground Terminal To Battery Sensor. Ref. To Repair Contents>Note>Battery .
- When The Central Gateway Control Module Has Been Replaced, Perform The Module Registration. Ref. To Common (Diagnostics)>Unit Registration>Operation .
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.