2025 Subaru Impreza BaseFACTORY OEM SERVICE PROCEDURE

Select Lever: Removal

NOTE:
  1. Disconnect the ground terminal from battery sensor. Ref. to REPAIR CONTENTS>NOTE>BATTERY .
  2. Remove the mat tray center. (Model without wireless charger)
    1. Release the clips using a flat tip screwdriver or similar tool wrapped with protection tape.
    2. Remove the mat tray center.
      G16767428Courtesy of SUBARU OF AMERICA, INC.
  3. Remove the wireless charger assembly. (Model with wireless charger) Ref. to ENTERTAINMENT & MONITORING>WIRELESS CHARGER>REMOVAL .
  4. Shift the select lever to "N range".
    1. Press the shift lock release button.
    2. Shift the select lever to "N range".
      G16767429Courtesy of SUBARU OF AMERICA, INC.
  5. Lower the section (A) of the boot. (Model with boot shifter)
    G16767430Courtesy of SUBARU OF AMERICA, INC.
  6. Lower the cover grip AT (A) vertically toward the lever. (Model with gate shifter)
    G16767431Courtesy of SUBARU OF AMERICA, INC.
  7. Remove the grip.
    1. Remove the clamp (A).
    2. Remove the grip.
      • Model with boot shifter
        G16767432Courtesy of SUBARU OF AMERICA, INC.
      • Model with gate shifter
        G16767433Courtesy of SUBARU OF AMERICA, INC.
  8. Remove the console box. Ref. to EXTERIOR/INTERIOR TRIM>CONSOLE BOX>REMOVAL .
  9. Remove the cover center side. Ref. to EXTERIOR/INTERIOR TRIM>CENTER CONSOLE>REMOVAL .
  10. Disconnect the connector.
    G16767434Courtesy of SUBARU OF AMERICA, INC.
  11. Remove the clips securing the harness.
    G16767435Courtesy of SUBARU OF AMERICA, INC.
  12. Remove the select lever.
    1. Remove the select cable. Ref. to CONTROL SYSTEMS>SELECT CABLE>REMOVAL .
    2. Remove the select lever.
      G16767436Courtesy of SUBARU OF AMERICA, INC.
Chapter Navigation
Return to Chapter: Select Lever
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

Shop Manual-Ready ToolsCompare Repair QuoteQuote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.