2025 Subaru Impreza BaseFACTORY OEM SERVICE PROCEDURE

LH Side

  1. Install the ignition coil and connect the connector (A).
    CAUTION: Degrease the mounting bolts, rocker cover installation portion and ignition coil installation hole.

    Tightening torque:Β 

    8 N.m (0.8 kgf-m, 5.9 ft-lb)

    G16761798Courtesy of SUBARU OF AMERICA, INC.
  2. Install the pipe evaporator cooling to the clip.
    G16761244Courtesy of SUBARU OF AMERICA, INC.
  3. Install the bolts and the nuts which secure the CVTF cooler pipe No. 2. (Model with CVTF cooler (air cool))
    NOTE: Use a socket with magnet (for preventing nut falling) to attach the nut through the gap of the front grille assembly.

    Tightening torque:Β 

    7.5 N.m (0.8 kgf-m, 5.5 ft-lb)

    G16761213Courtesy of SUBARU OF AMERICA, INC.
  4. Attach the bracket.

    Tightening torque:Β 

    7.5 N.m (0.8 kgf-m, 5.5 ft-lb)

  5. Place the engine wiring harness and secure the engine wiring harness to the bracket with the claw (A).
  6. Set the battery cable assembly, and secure the battery cable assembly to the bracket with claw (B).
    G16761246Courtesy of SUBARU OF AMERICA, INC.
  7. Install the engine wiring harness to the clip (A), and connect the connector (B) to the main fuse box.
  8. Connect the connector (C) to ECM. Ref. to FUEL INJECTION (FUEL SYSTEMS) (H4DO)>ENGINE CONTROL MODULE (ECM)>INSTALLATION .
    G16760428Courtesy of SUBARU OF AMERICA, INC.
  9. Install the battery. Ref. to STARTING/CHARGING SYSTEMS (H4DO)>BATTERY>INSTALLATION .
  10. Connect the ground terminal to battery sensor. Ref. to REPAIR CONTENTS>NOTE>BATTERY .
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.