2024 Subaru WRX BaseFACTORY OEM SERVICE PROCEDURE

Control Valve Body

Fig 1: Transmission Valve Body Component Location
G00574241Courtesy of SUBARU OF AMERICA, INC.
(1) Filter 
(2) O-ring 
(3) O-ring 
(4) O-ring 
(5) O-ring 
(6) Pressure pipe No. 1 
(7) Pressure pipe No. 2 
(8) Pressure pipe No. 3 
(9) CVTF pipe 
(10) O-ring 
(11) Control valve body 
(12) O-ring 
(13) Oil strainer 
(14) Magnet 
(15) Oil pan 
(16) Gasket 
(17) Drain plug 

Tightening torque: N.m (kgf-m, ft-lb) 

T1: 7.2 (0.7, 5.3) 

T2: 9 (0.9, 6.6) 

T3: 39.2 (4.0, 28.9) 

Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.