2024 Subaru WRX BaseFACTORY OEM SERVICE PROCEDURE

Extension Case: Disassembly

  1. Remove the dust cover.
    G14611247Courtesy of SUBARU OF AMERICA, INC.
  2. Remove the snap ring from the transfer clutch piston using the ST and a press.

    Preparation tool: 

    ST: COMPRESSOR SPECIAL TOOL (18762AA001)

    G14611248Courtesy of SUBARU OF AMERICA, INC.
  3. Remove the clutch spring retainer, return spring and spring retainer.
    G16539574Courtesy of SUBARU OF AMERICA, INC.
    (A)  Clutch spring retainer 
    (B)  Return spring 
    (C)  Spring retainer 
  4. Blow compressed air through the hole shown in the figure, and remove the transfer clutch piston.
    G14611250Courtesy of SUBARU OF AMERICA, INC.
  5. Remove the D-ring and O-ring from the transfer clutch piston.
    G14611251Courtesy of SUBARU OF AMERICA, INC.
  6. Remove the pressure plate and ball bearing.
    G16539577Courtesy of SUBARU OF AMERICA, INC.
    (A)  Pressure plate 
    (B)  Ball bearing 
    (C)  Transfer clutch piston 
  7. Remove the extension case oil seal. Ref. to CONTINUOUSLY VARIABLE TRANSMISSION (TR690)>EXTENSION CASE OIL SEAL>REPLACEMENT .
  8. Remove the plug.
    G14611253Courtesy of SUBARU OF AMERICA, INC.
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.