Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2024 Subaru WRX BaseFACTORY OEM SERVICE PROCEDURE
Inspection Mode Q
| DTC | Description & trouble part | Condition | Number of driving cycles on the detecting condition |
|---|---|---|---|
| P0017 | CRANKSHAFT POSITION - CAMSHAFT POSITION CORRELATION BANK 1 SENSOR B | [Coolant Temp.]: 80°C (176°F) or more | 2 |
| P0019 | CRANKSHAFT POSITION - CAMSHAFT POSITION CORRELATION BANK 2 SENSOR B | [Coolant Temp.]: 80°C (176°F) or more | 2 |
- Using the Subaru Select Monitor, perform the clear memory of [Engine]. Ref. to COMMON (DIAGNOSTICS)>CLEAR MEMORY .
- Idle the engine for at least one minute.
- Read the pending code of DTC using the Subaru Select Monitor or general scan tool.NOTE:
- For detailed operation procedures, refer to "COMMON (DIAGNOSTICS)". Ref. to COMMON (DIAGNOSTICS)>DIAGNOSTIC TROUBLE CODE (DTC) .
- If the DTC is not displayed on the Subaru Select Monitor or general scan tool display screen, the trouble is resolved.
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.