Name: AllOEMManuals
Address: 316 Brandywine Ave, Streetman, TX, 75859, US
Telephone: +14699867883
Price range: $$

On [Start] screen, select [Diagnosis].
On [Vehicle selection] screen, input the target vehicle information and select [OK].
On [Main Menu] screen, select [Each System].
On [Select System] screen, select the corresponding system and select [Enter].
On [Select Function] screen, select [DTC].

NOTE:

For detailed operation procedures, refer to "Help" of application .
When using the Subaru Select Monitor, turn the ignition switch to ON .
Sub screen may appear in the system selection display. In that case, select appropriate items in accordance with the contents of the display .
Current code is a diagnostic code displayed when the system is judging the current code. However, if a DTC is recorded due to poor contact etc., the code remains displayed as current code during the drive cycle even after the poor contact has resolved .
Pending code is a trouble code that displays the malfunction in 1st driving cycle as a temporary malfunction, in the diagnostic code where a malfunction is detected in 2nd driving cycles .
History code is a diagnostic code recorded when the current code is not detected but the system has detected a malfunction in the past. When the current code is recorded, it is also recorded to the history code at the same time .

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

• You smell fuel, burning insulation, or see smoke.

• Brakes feel soft, pull hard to one side, or make grinding noises.

• The engine overheats, stalls repeatedly, or misfires under load.

• You are missing required tools, torque specs, or safe lifting equipment.

• You are not confident in the next step or safety outcome.

Safety Warning

Diagnostic Trouble Code (DTC): Operation