2024 Subaru WRX BaseFACTORY OEM SERVICE PROCEDURE

Components With Torque Specifications: Starter

  • CVT model
Fig 1: Starter Motor Components Location - CVT Model
G00674233Courtesy of SUBARU OF AMERICA, INC.
(1) Cable stay
(2) Starter housing
(3) Shift lever
(4) Plate
(5) Seal rubber
(6) Magnet switch ASSY
(7) Snap ring
(8) Stopper
(9) Overrunning clutch
(10) Internal gear
(11) Shaft
(12) Pinion gear
(13) Yoke ASSY
(14) Armature ASSY
(15) Brush holder ASSY
(16) Starter cover

Tightening torque: N.m (kgf-m, ft-lb) 

T1: 3.4 (0.3, 2.5) 

T2: 3.5 (0.4, 2.6) 

T3: 10.7 (1.1, 7.9) 

T4: 11 (1.1, 8.1) 

T5: 50 (5.1, 36.9) 

  • MT model
Fig 2: Starter Motor Components Location - MT Model
G00674234Courtesy of SUBARU OF AMERICA, INC.
(1) Cable stay
(2) Starter housing
(3) Shift lever
(4) Plate
(5) Seal rubber
(6) Magnet switch ASSY
(7) Snap ring
(8) Stopper
(9) Overrunning clutch
(10) Internal gear
(11) Shaft
(12) Pinion gear
(13) Yoke ASSY
(14) Armature ASSY
(15) Brush holder ASSY
(16) Starter cover

Tightening torque: N.m (kgf-m, ft-lb) 

T1: 3.4 (0.3, 2.5) 

T2: 5.9 (0.6, 4.3) 

T3: 6.1 (0.6, 4.5) 

T4: 10.7 (1.1, 7.9) 

T5: 11 (1.1, 8.1) 

T6: 50 (5.1, 36.9) 

Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.