Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2024 Subaru Outback WildernessFACTORY OEM SERVICE PROCEDURE
Select Lever And Select Cable
| (1) | Clamp |
| (2) | Grip |
| (3) | Boot |
| (4) | Adjusting nut (rear) |
| (5) | Adjusting nut (front) |
| (6) | Select cable |
| (7) | Washer |
| (8) | Snap pin |
| (9) | Cable bracket |
| (10) | Clamp |
| (11) | Connector pin |
| (12) | Select lever |
| (13) | Indicator ASSY (Type A) |
| (14) | Indicator ASSY (Type B) |
| (15) | Cover front panel |
| (16) | Indicator ASSY (Type C) |
Tightening torque: N.m (kgf-m, ft-lb)
T1: 7.5 (0.8, 5.5)
T2: 18 (1.8, 13.3)
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.