2024 Subaru Outback BaseFACTORY OEM SERVICE PROCEDURE

Select Cable: Adjustment

  1. Release the shift lock and shift the select lever to the "N range". Ref. to CONTROL SYSTEMS>SELECT LEVER>REMOVAL .
  2. Remove the center exhaust cover and rear exhaust pipe.

    H4DO model: 

    Ref. to EXHAUST (H4DO)>REAR EXHAUST PIPE>REMOVAL .

    H4DOTC model: 

    Ref. to EXHAUST (H4DOTC)>REAR EXHAUST PIPE>REMOVAL .

  3. Remove the center exhaust pipe (rear). (H4DOTC model) Ref. to EXHAUST (H4DOTC)>CENTER EXHAUST PIPE>REMOVAL>CENTER EXHAUST PIPE (REAR) .
  4. Loosen the adjusting nut (front) and adjusting nut (rear).
    G14602414Courtesy of SUBARU OF AMERICA, INC.
  5. Turn the adjusting nut (front) until it lightly touches the connector pin.
    G16387252Courtesy of SUBARU OF AMERICA, INC.
    (A) Front side
    (B) Downside
    (C) Select lever
    (D) Adjusting nut (rear)
    (E) Connector pin
    (F) Contact point
    (G) Adjusting nut (front)
  6. While holding the adjusting nut (front) in place, tighten the adjusting nut (rear).

    Tightening torque: 

    7.5 N.m (0.8 kgf-m, 5.5 ft-lb)

  7. After the completion of adjustment, check that the select lever operates normally at all ranges.
  8. Install the center exhaust pipe (rear). (H4DOTC model) Ref. to EXHAUST (H4DOTC)>CENTER EXHAUST PIPE>INSTALLATION>CENTER EXHAUST PIPE (REAR) .
  9. Install the center exhaust cover and rear exhaust pipe.

    H4DO model: 

    Ref. to EXHAUST (H4DO)>REAR EXHAUST PIPE>INSTALLATION .

    H4DOTC model: 

    Ref. to EXHAUST (H4DOTC)>REAR EXHAUST PIPE>INSTALLATION .

  10. Release the shift lock and shift the select lever to the "P range". Ref. to CONTROL SYSTEMS>SELECT LEVER>INSTALLATION .
Chapter Navigation
Return to Chapter: Select Cable
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

Shop Manual-Ready ToolsCompare Repair QuoteQuote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.