2024 Subaru Outback BaseFACTORY OEM SERVICE PROCEDURE

Transmission Harness And Sensor

Fig 1: Transmission Wiring Harness, Speed Sensors, Turbine Sensor, And Line Pressure Sensor Component Location
G16341812Courtesy of SUBARU OF AMERICA, INC.
(1) Air breather cap
(2) Transmission case cover
(3) Transmission case cover (front) (B type)(1)
(4) Transmission case cover (rear)
(5) Air breather hose
(6) Air breather hose bracket
(7) Air breather nipple
(8) Air breather hose bracket
(9) Air breather nipple
(10) Transmission harness
(11) O-ring
(12) O-ring
(13) Secondary pressure sensor
(14) O-ring
(15) Primary speed sensor
(16) Spacer
(17) Secondary speed sensor
(18) O-ring
(19) Turbine speed sensor (front) (A type)(1)
(20) Line pressure sensor
(1) Bolt mounting position varies depending on the shape of the transmission case cover (front).

Tightening torque: N.m (kgf-m, ft-lb)Β 

T1: 7 (0.7, 5.2)Β 

T2: 8 (0.8, 5.9)Β 

T3: 13 (1.3, 9.6)Β 

Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.