2024 Subaru Outback BaseFACTORY OEM SERVICE PROCEDURE

H4DO Model

CAUTION:
  • When raising the transmission jack, make sure that the tie-rod end and the drive shaft boot do not interfere. The drive shaft boot may be damaged.
  • For the non-reusable parts, always use new parts.
  • Always tighten the bushing in the state where the vehicle is at curb weight and the wheels are in full contact with the ground.
  • Install the clamp stabilizer with the peak of triangle facing the front of the vehicle.
G14384643Courtesy of SUBARU OF AMERICA, INC.
NOTE:
  • The rubber bushing stabilizer front can be used with its slit facing either front or rear.
  • The left and right clamp stabilizers differ in shape.
  1. Install the crossmember COMPL front.
    CAUTION:
    • After installing the crossmember, check that there is no clearance or looseness between it and the body.
    • Do not forget to install the spacer. (Except for sedan model)
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.