2024 Subaru Outback BaseFACTORY OEM SERVICE PROCEDURE

Engine Cooling System

WARNING: This page is about a different variant/trim than selected.
G16385010Courtesy of SUBARU OF AMERICA, INC.
(1) Water pump cover
(2) Water pump pulley
(3) Water pump ASSY
(4) Thermostat
(5) Gasket
(6) Thermostat cover
(7) Water pipe LH
(8) O-ring
(9) Clip
(10) Preheater hose
(11) Clip
(12) Water hose
(13) O-ring
(14) Engine coolant temperature sensor
(15) Gasket
(16) Preheater hose
(17) Clip
(18) Water hose
(19) Water tank pipe ASSY
(20) Clip
(21) Water hose
(22) Water pipe RH
(23) Water hose
(24) Thermostat cover
(25) Gasket
(26) Thermostat

Tightening torque: N.m (kgf-m, ft-lb) 

T1: 6.4 (0.7, 4.7) 

T2: 14 (1.4, 10.3) 

T3: 16 (1.6, 11.8) 

T4:  Ref. to COOLING (H4DOTC)>WATER PIPE>INSTALLATION>WATER PIPE LH .

Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.