Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2024 Subaru Outback BaseFACTORY OEM SERVICE PROCEDURE
Engine Unit
| (1) | Fuel pressure sensor |
| (2) | Engine coolant temperature sensor (outlet) |
| (3) | Manifold absolute pressure sensor |
| (4) | Knock sensor |
| (5) | Throttle position sensor |
| (6) | Crankshaft position sensor |
| (7) | High-pressure fuel pump |
| (8) | Rear catalytic converter |
| (9) | Rear oxygen sensor |
| (10) | Intake camshaft position sensor |
| (11) | Exhaust camshaft position sensor |
| (12) | Front catalytic converter |
| (13) | Front oxygen (A/F) sensor |
| (14) | Engine coolant temperature sensor (inlet) |
| (15) | Intake oil control solenoid |
| (16) | Exhaust oil control solenoid |
| (1) | Tumble generator valve actuator |
| (2) | Purge control solenoid valve |
| (3) | EGR control valve |
| (4) | Thermo control valve ASSY |
| (5) | Engine oil temperature sensor |
| (6) | Oil pressure sensor |
| (7) | Fuel injector |
| (8) | Ignition coil |
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.