When the control module is replaced, it is possible to save the customizing information set for the vehicle to the Subaru Select Monitor, and write it to the new control module.

On [Start] screen, select [Diagnosis].
On [Vehicle selection] screen, input the target vehicle information and press [OK].
On [Main Menu] screen, select [Customize].
On [Select System] screen, select the corresponding system and press [Select].
NOTE: By selecting [All system], you can save all customize items in All system.
On [Customize] screen, press [Save settings].
Save the file.
Replace the control module, then connect the Subaru Select Monitor.
On [Start] screen, select [Diagnosis].
On [Select System] screen, input the target vehicle information and press [OK].
On [Main Menu] screen, select [Customize].
On [Select Function] screen, select the corresponding system and press [Select].
On [Customize] screen, press [Read settings].
After the data is read out, press [Change] to perform reading.
NOTE: For detailed operation procedures, refer to "Application help".

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

• You smell fuel, burning insulation, or see smoke.

• Brakes feel soft, pull hard to one side, or make grinding noises.

• The engine overheats, stalls repeatedly, or misfires under load.

• You are missing required tools, torque specs, or safe lifting equipment.

• You are not confident in the next step or safety outcome.

Safety Warning

Save settings / Read settings

Use the Manual With the Right Hardware

When to See a Mechanic