Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2024 Subaru Outback BaseFACTORY OEM SERVICE PROCEDURE
Fuel Injector
| (1) | Fuel pressure sensor |
| (2) | Fuel injector pipe RH* |
| (3) | Fuel injector holder |
| (4) | Stopper ring |
| (5) | O-ring seal |
| (6) | Back-up ring |
| (7) | Fuel injector |
| (8) | Slider washer |
| (9) | C-ring |
| (10) | Fuel injector seal |
| (11) | Fuel injector pipe LH |
| (12) | Coupling harness |
*: When removing the fuel pressure sensor from the fuel injector pipe RH, replace it with a new one.
Tightening torque: N.m (kgf-m, ft-lb)
T1: 19 (1.9, 14.0)
T2: 46 (4.7, 33.9)
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.