2024 Subaru Impreza BaseFACTORY OEM SERVICE PROCEDURE

Select Cable: Removal

NOTE: Components: Ref. to CONTROL SYSTEMS>GENERAL DESCRIPTION>COMPONENT>SELECT CABLE .
  1. Release the shift lock and shift the select lever to the "N range". Ref. to CONTROL SYSTEMS>SELECT LEVER>REMOVAL .
  2. Remove the center exhaust cover. Ref. to EXHAUST (H4DO)>REAR EXHAUST PIPE .
    NOTE: Remove the center exhaust cover only.
  3. Disconnect the select cable from the transmission main body.
    CAUTION: Do not apply excessive load while holding the part (a).
    G14602401Courtesy of SUBARU OF AMERICA, INC.
    G16767440Courtesy of SUBARU OF AMERICA, INC.
  4. Remove the cable plate.
    NOTE: Perform this procedure only when required.
    G16767441Courtesy of SUBARU OF AMERICA, INC.
  5. Remove the adjusting nut (rear).
    G14602403Courtesy of SUBARU OF AMERICA, INC.
  6. Remove the select cable.
    CAUTION: Do not apply excessive load while holding the part (a).
    G14602404Courtesy of SUBARU OF AMERICA, INC.
    1. Raise the claw of the clamp.
    2. Remove the select cable together with the clamp.
      G14602405Courtesy of SUBARU OF AMERICA, INC.
  7. Remove the clamp from the select cable.
  8. Remove the connector pin.
    NOTE: Perform this procedure only when required.
    G16767445Courtesy of SUBARU OF AMERICA, INC.
Chapter Navigation
Return to Chapter: Select Cable
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

Shop Manual-Ready ToolsCompare Repair QuoteQuote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.