Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2024 Subaru Impreza BaseFACTORY OEM SERVICE PROCEDURE
Work Support: List
WARNING: This page is about a different variant/trim than selected.
| Work Support item | Contents | Remarks |
|---|---|---|
| Simple Roughness Monitor | Engine speed and misfiring counter for each cylinder can be displayed. |
|
| High-Grade Roughness Monitor (without harness) | Standard deviation, engine speed, etc. can be calculated based on the pulse data of crankshaft position sensor and camshaft position sensor, and the value and graph can also be displayed. |
|
| Engine Coolant Air Purge Mode | The thermo-control valve circuit can be set to partial throttle in order to fill the engine coolant. | Setting is allowed when the following conditions are established.
|
| Entry VIN | V.I.N. can be registered. | Ignition switch ON (engine OFF) |
| Evaporative System Leak Test | The EVAP system is diagnosed by forcibly actuating the ELCM. | Execution condition
|
| Control Operation History | If the maximum vehicle speed and maximum engine speed are each out of standard, the history data that consists of the latest data and top three data (four data in total) of each item can be displayed. (Up to 12 data) The following items are to be saved.
|
|
| Clear Learning Value | Clear the learning value saved in ECM. | - |
If Control Operation History is recorded
| History | Part | Main symptoms | Main faulty parts | Main factors |
|---|---|---|---|---|
| Maximum engine speed | Engine | Rough idle and engine stall Low output, hesitation and poor acceleration |
Crankshaft bearing | Improper shift operation Vehicle modification |
| Connecting rod bearing | ||||
| Piston | ||||
| Valve | ||||
| Valve spring | ||||
| Cylinder head | ||||
| Camshaft | ||||
| Cylinder block | ||||
| CVT | Noise Poor acceleration Slipping Vibration |
Torque converter | ||
| Oil pump | ||||
| Clutch | ||||
| Variator (chain, pulley) | ||||
| Gear | ||||
| Bearing | ||||
| Diff. | Noise Vibration |
Gear | ||
| Bearing | ||||
| Maximum vehicle speed | CVT | Noise Poor acceleration Slipping Vibration |
Torque converter | Vehicle modification Vehicle malfunction |
| Oil pump | ||||
| Clutch | ||||
| Variator (chain, pulley) | ||||
| Gear | ||||
| Bearing | ||||
| Diff. | Noise Vibration |
Gear | ||
| Bearing |
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.
